problem signature 05 autofailover windows 7

I guess the cause of the issue is it failed to detect the existence of the Windows system at all. The same error message appeared as shown above. Info: An error occurred while attempting to read the boot configuration data. A recent hardware or software change might be the cause. The following message showed up this time (instead of going straight to startup repair). I tried to run the following command in the USB drive. This is what is normally shown, but the list is empty in my case.Ĥ. Clearly Windows partition is at Drive D, but for some reasons it failed to detect.

When I ran the system recovery option from the USB drive, the system did not list any operating system or drive in the list. I ran chkdsk via command prompt from the USB drive to check Drive C too. No bad sector was found in the Windows partition (Drive D). Previously I ran chkdsk from the startup repair (not from the USB drive) through command prompt. What's up? How could I fix so it could boot again? Thank you.ģ. They simply went straight to the 'Startup Repair' loop. I tried to press F8 rapidly or held down F8 key once computer started. I tried twice to boot into safe mode but failed. System restore failed while logging in to restore from the restore point.Īn unspecified error occurred during system restore. (not exact wording since using another language) After about 15 minutes, it stated it failed to repair with the following errors: When Windows started, it went directly into Startup Repair.

I was no longer able to boot into Windows after that. Comodo Internet Security couldn't start properly one day.

Problem signature 05 autofailover windows 7